ALZO Short Suspended Drop Ceiling Video Projector Mount with Scissor Clamp for T-Bar Attachment with 10 Inch Drop

• Easy to install on a suspended drop ceiling with a 1-inch wide T-Bar frame,
• Projector drop from the ceiling is 10 inches, and accessory extension rods can be added to lower the projector
• 2-axis locking tilt adjust with maximum 25 degrees pitch makes installation fast and stable
• Mount fits all larger projectors with 3 to 4 mounting screw holes weighing up to 10-pounds, but for projectors over 2 pounds, we recommend reinforcing the T-bar frame with a support wire that attaches to the true ceiling; Click Load Specifications tab
• Fits Epson, Optoma, Benq, Viewsonic and most other video projectors.
• Includes an American written installation manual with illustrations and photos
• Includes scissor clamp and one 8 inch aluminum suspension rod
• The projector is not included; it is shown for demonstration purposes only

This easy to install video projector mount can support up to a 20-pound projector* from the T-Bar framing of a suspended drop ceiling. See the Load Specifications tab. The simple assembly includes all metal parts and a kit of assembly screws and hardware. The two-axis locking tilt adjust with about 25 degrees pitch makes installation fast and stable. Attaches to your projector with 3 or 4 legs of the gimbal spider mount.

The maximum spider mount leg span is 12 inches (mount hole to mount hole); angling the legs will slightly reduce the maximum leg span.

Typical mounting screws are supplied with this mount but with some projectors, you may need to use the mounting screws included with your projector. Fits Epson, Optoma, Benq, Viewsonic and most other projectors.

Projector drop from the ceiling is only 10 inches. Includes an American written installation manual. Accessory 8-inch extension rods can be added to lower the projector, see below for accessory rods.

Video Projector is not included, it is shown for demonstration purposes.

NOT COMPATIBLE WITH ViewSonic PJD7820HD projector.

* may require adding additional suspended ceiling support wires as indicated in the installation manual.

Click here for projector mount accessories

Click here for ALZO Installation manual

The standard rated load of the ALZO Suspended Drop Ceiling Photo Video Projector Mount Kit is 4 pounds, assuming a proper secure attachment of the suspended ceiling T-Bar frame to the true ceiling.

When exceeding 4 lbs. of total supported weight, additional suspended ceiling T-Bar frame support wires must be affixed near the mounting scissor clips to the true ceiling. If the light mount scissor clips are located near the true ceiling support wires, and these wires are sufficient strength, then the weight of the projector could be as high as 10 pounds.