ALZO Liberator Plate User Guide
Place the plate on the camera base as shown and start the screw with 2 turns. Then remove the adhesive protective film, rotate the plate into position and press plate in place. Then carefully tighten the screw with the hex key. DO NOT OVER-TIGHTEN THE SCREW.
The double sided 3M squares supplied with the ALZO Liberator plate can be replaced with 3M squares that can be purchased at most office supply stores or on AMAZON. In addition, this tape can be washed with dish detergent to restore stickiness.
HOW TO WASH 3M SQUARES
Apply only 1 drop of dish detergent to each side of the square and rub between the fingers. Rinse the square thoroughly and then shake off all excess water, Hang the square by one corner to dry. Do not use paper or cloth towel to dry the square as this will deposit lint on the square and reduce stickiness. After a few hours of drying time the square is ready for use.